Trane Gas Unit Heaters Instalační manuál stáhnout pdf (Strana 30)

30 GUNE-SVX001A-EN

Gas Equipment Start-Up

Pre-inspection information (with power and gas off)

Customer Job Name & Number

Type of Equipment: Duct Furnace Type of Gas (Natural or LP)

Serial Number: Tank Capacity ____lb ____kg

Name Plate Voltage:

Rating

____Btu@ ____°F

Name Plate Amperage ____kW@ ____°C

Model Number

Table 12. Startup checklist

Verify Task

Completed

Are all panels, doors, vent caps in place?

Has the unit suffered any external damage? If so, identify damage:

Does the gas piping and electric wiring appear to be installed in a professional manner?

Has the gas and electric been inspected by the local authority having jurisdiction?

Is the gas supply properly sized for the equipment?

Were the installation instructions followed when the equipment was installed?

Have all field installed controls been installed?

Do you understand all the controls on this equipment? If not, contact your wholesaler or rep.

(DO NOT START this equipment unless you fully understand the controls.)

General (with power and gas off)

Make certain all packing has been removed.

Tighten all electrical terminals and connections.

Check all controls for proper settings.

Gas Heating (with power and gas on)

Inlet gas pressure. ____ inches wc or ____ kPa

Burner ignition.

Manifold gas pressure.____ inches wc or ____ kPa

Check electronic modulation. Set at: __________

Cycle and check all other controls not listed.

Check operation of remote panel.

Entering air temp. _____ °F or ____ °C

Discharge air temp. (high fire) ____ °F or ____ °C

External static pressure _________ inches wc

Cycle by thermostat or operating control.

Combustion reading

Carbon Monoxide _____ PPM

Carbon Dioxide _____%

Remarks

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Žádné komentáře

Trane Gas Unit Heaters Instalační manuál Strana 30